Greetings, and welcome back to my channel! My name is Azeem, and you’re tuned into The Lab. I know it’s been ages since I last uploaded a video – over two years, in fact. The past few years have been a whirlwind for me, but I’m thrilled to announce my return with some exciting news!
As you can see, I have a brand-new ride parked beside me. I’ve craved a motorcycle for the longest time, and now that I’ve recently turned 20, I figured it was the perfect time to treat myself. It’s a modest starter bike, but it’s a great one – a 2015 Yamaha R3.
I’ve only had the bike for a week, but I’ve already ordered a slew of parts. I’ll be sharing videos of the installation process as they arrive. However, today, I’m showcasing one of the components I was most eager to get my hands on – a full exhaust system. It’ll replace the entire setup, from the headers to the tailpipe.
Let’s take a closer look at the exhaust. It consists of a few key components. First, we have these two headers that connect to a two-into-one pipe. Then, there’s a mid-pipe that will house the O2 sensor. Finally, there’s the tailpipe, which will connect to the slip-on muffler. The kit also includes a baffle, which I’ll decide whether to install based on the sound the exhaust produces.
Before we dive into the installation, let’s hear how the bike sounds with the stock muffler.
[Original exhaust sound clip plays]
Now, let’s get rid of that muffler! The first step is to remove the OEM muffler, which is fairly straightforward. Using an Allen key, I’ll remove the bolts holding the bracket and clamp in place. And there it is – the stock muffler is off, revealing the headers.
Next, it’s time to remove the exhaust itself. I’ve applied some WD-40 to the bolts to make the process smoother. There are four bolts on each side, which I’ll loosen using a 12 mm wrench. Once they’re loose, I can use my hands to wiggle the exhaust free.
To remove the mid-pipe, I’ll need to disconnect the O2 sensor. It’s located behind the headers, and I’ll use an Allen key to remove the bolt holding it in place. Then, I can unscrew the O2 sensor and pull it out.
With the O2 sensor removed, I can disconnect the mid-pipe from the headers. There are two mounting points on the exhaust, and I’ll need to remove the bolts holding them in place. Once those are removed, I can swing the exhaust to the side and disconnect it from the cat.
Now that the old exhaust is out of the way, it’s time to install the new one. I’ll start by connecting the headers to the two-into-one pipe. The kit includes spring-loaded clamps, which I’ll tighten using an Allen key.
Next, I’ll connect the mid-pipe to the two-into-one pipe. I’ll slide it into place and secure it with a spring clamp. Then, I’ll connect the tailpipe to the mid-pipe and secure it with another spring clamp.
Finally, I’ll reattach the O2 sensor to the mid-pipe and tighten it into place. With everything connected, I’ll torque the bolts to the specified tightness.
Now, let’s fire up the bike and hear how it sounds with the new exhaust!
[Modified exhaust sound clip plays]
As you can hear, the exhaust is significantly louder than the stock one. I’m not sure if I’ll keep the baffle in or not. I’ll ride the bike for a bit and see how it feels.
Overall, the installation process was relatively straightforward, although it did take some time. I’m thrilled with the results and can’t wait to share more videos with you as I continue to modify my bike.
Thank you for watching! My name is Azeem, and this is The Lab. See you next time!